Electrix Tweaker Editor Reference Manuale Utente

WWW.ELECTRIXPRO.COMTWEAKER EDITOR REFERENCE MANUAL

3. Control Settings10Enter a CC number that you want the drum pad to send on aftertouch (that is, holding down and pressing the pad). Valid CC numbers

3. Control Settings113.7 Global SettingsThe global settings aect all controls.Encoder SpeedsYou can set two dierent speeds for encoders. Speed A is

3. Control Settings12any channel settings of the incoming message and respond accordingly. For example, suppose the TWEAKER’s bottom left button is co

3. Control Settings13ReturnThe pressure at which a pad generates a Note O Message (and stops streaming CC Messages).Min: 0Max: 1023Default: 15Not

3. Control Settings14DeletePress this button to delete the currently selected preset. You’ll be asked for conrmation before you commit this change! T

4. Save to Tweaker154 Save to Tweakeri The save function is very important! Read carefully. When the TWEAKER is connected to power, settings are reca

5. Tools165 ToolsThe tools window hosts a variety of utilities that help you test your controller’s setup as well as have a little bit of fun! These t

5. Tools17message this sends. Just type in a note number into the box and the note will be sent, or type in a velocity value and the note will be sent

6. MIDI Hub186 MIDI HubThe MIDI Hub provides a mechanism to direct MIDI from another application (over a MIDI loopback/IAC port) to the controller so

6. MIDI Hub196.1 Windows Setupi You’ll need to install a 3rd-party ‘MIDI loopback port’ application to use the Hub. We recommend MIDI Yoke, which ca

Tweaker Editor Reference Manual2Table of Contents1 Getting Started 3 1.1 Before You Begin 3 1.2 Installing the Editor 3 1.3 Connecting the

7. The Settings Channel207 The Settings ChannelThe settings channel is reserved for the use of standard MIDI CC messages to congure dierent TWEAKER

8. SysEx Messages218 Sysex MessagesThe TWEAKER EDITOR uses SysEx (System Exclusive) messages to communicate all changes to the TWEAKER. Complete docum

Electrix is a Division of Mixware, LLC11070 Fleetwood St, Unit FSun Valley, CA 91352USAwww.electrixpro.com© 2012 Mixware, LLC. All rights reserved. Tw

1. Getting Started31 Getting Started 1.1 Before You BeginJava 1.6 or above is required. For the Windows operating system, you can go to http://www.j

1. Getting Started41.3 Connecting the TweakerA TWEAKER must be connected to your computer before starting the editor. When the TWEAKER EDITOR rst st

2. Overview52 OverviewThe ELECTRIX TWEAKER EDITOR provides a complete interface for modifying the settings and controls of the TWEAKER control surface

2. Overview6Some of the changes that you can explore are:8 Enable and disable local control of LED rings and button LED’s8 Create preset les that ar

3. Control Settings73 Control SettingsWhen you select a control, either by clicking on the interface or using a control on the TWEAKER, the Control S

3. Control Settings8eect. If a button is congured as enc speed, it will send no MIDI messages.3.2 Sliders and Potscc#Enter CC number that you want

3. Control Settings93.4 LED RingsThe LED rings for the encoders can be controlled independently of the encoder value. This is useful if you want to u