Electrix Framing System Manuale Utente Scaricare il pdf (Pagina 2)

Installation Instructions

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance

with the National Electrical Code and local regulations.

To assure full compliance with local codes and

regulations, check with your local electrical inspector

before installation. To prevent electrical shock, turn

off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

45 SPRING STREET • P.O. BOX 9575

NEW HAVEN, CONNECTICUT 06535-0575

NOTE: This instruction sheet covers several fixture styles.

Lamp type and ballast may vary slightly from that shown,

although installation is the same.

WARNING: FOR SUPPLY CONNECTIONS USE

WIRE RATED FOR AT LEAST 90°C.

CAUTION: MAKE CERTAIN WIRES ARE NOT

PINCHED BETWEEN PARTS.

CAUTION: MAXIMUM WATTAGE AS MARKED ON

FIXTURE MUST NOT BE EXCEEDED.

P/N 01LL-SR

LumiLedge

SR - PATENT PENDING

4. Make through wire connection to next ﬁxture.

See Figure C.

5. Slide ﬁxtures end to end and fasten ﬁxture to

sheetrock support bracket. Continue

through complete cove. Figure D.

Caution: Be careful not to pinch wires

between luminaries.

6. Set reﬂectors in proper position and attach

reﬂector link bracket to ensure consistent

performance of reﬂector. Figure E.

1 2

Nessun commento

Electrix Framing System Manuale Utente Pagina 2